NonProgrammable Thermostat for Home, Single-Stage Systems,Digital Energy-Saving Thermostat,1 Heat/1 Cool, Easy DIY Install,White Backlight
$20.45
Related Products
Product description
STN601-White
STN601-White
Simple thermostat for home,room temperature controller,temperature regulator for heating and cooling,house furnace,gas fireplaces,AC unit,millivolt control panel,temperature switch,non programmable thermostat,push button wall thermostat DIY,hvac fan
High Compatibility: Forced air (gas, oil or electric), Electric furnace, Hot water steam or gravity radiant heat, Heat only systems, Heat pump w/o auxiliary or emergency heat, Millivolt, Gas fireplaces (24V), Floor or wall furnaces, Cool only systems.(TIP: Before purchasing, check to see if this thermostat is compatible with your system.)
Not Compatible: Heat pump with auxiliary or emergency heat, Dual fuel/hybrid heating, Electric baseboard heat (110-240 volts), Line voltage, Convectors, Radiant-ceiling heat, Mini split systems and 12V RV systems.
Easy to Install and Use: Large terminal blocks with universal sub-base, can be installed within 30 minutes, clear, easy-to-read backlight LCD display and easy controls make for a user-friendly experience.
Simple but Powerful Control: Easy-access front-load battery compartment, adjustable temperature differential (swing) for energy optimization and maximum system life, Support temperature display calibration, Convert °C/°F units, compressor delay protection (selectable on or off).
Dual Power Supply: Can be powered by 24VAC power or 2 AAA batteries, No common wire (C-wire) required on most systems (only required on heat only and cool only systems).
13 reviews for NonProgrammable Thermostat for Home, Single-Stage Systems,Digital Energy-Saving Thermostat,1 Heat/1 Cool, Easy DIY Install,White Backlight
Add a review
$20.45
Nigel R. Guest –
Perfect. Performs exactly as described
I initially ordered two programmable thermostats. One turned out to be for baseboard heaters (do they still exist?) and the other one’s programming was impossibly complex and poorly documented, so both orders were canceled/returned. As I’m retired and live in a Mediterranean climate, I wouldn’t benefit from complex settings anyway (time of day, weekends, etc), so I decided to keep life simple and bought this. It was easy to install and works perfectly. It even has limited setting adjustments – room temperature calibration, setpoint and hysteresis (temperature difference between on and off).Update: If I could give this 6 stars, I would. The display is perfect. It shows you exactly what you need, with no unnecessary clutter. it illuminates if you touch one of the up or down buttons, otherwise it saves the battery by not being lit up.
nezih –
Must have for an old house!
This thermostat is a must if you live in an old, drafty house. Here is my experience: I have a gas furnace in my 120-year-old house that used to be controlled by an old-school thermostat where you could only adjust the desired temperature, and that was it. The heat used to kick in very often (over 10 times an hour) since the house is drafty, thanks to single-pane glass everywhere and barely any insulation. Installation of this thermostat was a breeze and took less than 10 minutes. The best feature is the “swing” adjustment. It allows me to set the temperature to 66°F with a 2°F swing, which means it kicks in once the temperature reaches or drops below 66°F, heats the house up to 68°F, and then does not kick in again until the house cools back down to 66°F, preventing short cycling. I monitor the on/off cycles of the fan through a smart breaker and track gas usage by keeping an eye on the meter. According to the data, I am using less gas and electricity while keeping the house 2 degrees warmer, which is incredible. I highly recommend it.
Danni Akers –
Nice, accurate, very adaptable, easy to install thermostat.
This seems to be a nice, easy to operate, accurate, adaptable thermostat. The installation and wiring were a breeze and the screw holes in the base of the thermostat lined up perfectly with my old Carrier thermostat holes, so no drilling for me. Just some touch up paint since this thermostat is slightly smaller than my old one. I’ve added some scans of the installation manual showing the wiring schemes and the procedures for adjusting the differential and calibrating the temperature reading. Out of the box, the heating differential is 0.4 deg F and cooling differential is deg 0.5 F. To clarify, this means the heat when set to 65 deg F, for example, it will turn on when the temp drops to 59.6 deg F and turn off when the temp rises to 65.4 deg F. You can set the differential as low as 0.2 deg F and as high as 2 deg F. The calibration of the unit, out of the box, was spot on to my traceable thermometer, so no adjustment needed there, but it is easily done. It is important to note, that in order to preserve batteries, you really need to connect the common (if available) from the 24VAC transformer to C terminal on the thermostat. Otherwise, the thermostat and its internal circuitry (it has at least one internal relay for example) will be powered by the batteries only, 24/7. The batteries probably won’t last very long operating in this configuration.Additionally, don’t forget to set the GAS/ELEC fan mode switch on the back of the thermostat before snapping the thermostat into place on the base during installation. In the GAS mode, the thermostat will not independently turn on the blower fan when the demand for heat signal is sent. In the ELEC mode the thermostat will turn on the fan (via green wire) at the same time the heat demand signal is sent. The default, out of the box, position of this switch is GAS.
Karen –
Works great!
Easy to install. Looks great and works great!
Vern Hess –
Awesome backup Thermostat or landlord special.
Landlord special. Or great to have if your’s goes out when everything is closed. The swing Temp keeps the house warm. It get the temp 1⁰ above the setting and kicks back on 1⁰ below and that most likely saves evergy vs kicking on at every degree drop in temperature. Better than anything walmart has in stock and simple to install, took 10 minutes. Large numbers easy to read. Very simple to control. Temp is very accurate.
Julie Kulman –
Easy to install
This is super easy to install, nice backlight. Very bright and easy to read. Works well, the heat kicks on as it should. I recommend it!
Bernadette Barr –
Thermostat
This worked very well & was a super value. My husband installed it very easily. I would highly recommend this thermostat.
RS –
Perfect replacement
Great replacement. Simple and accurate
Hector –
Muy buen equipo
daniel bob –
Great unit worked out well.
Kim Renwick –
These work awesome where I don’t need them programmed.
Jack Howton –
works great
Reg Stranks –
very good and easy to install